Summary
The Specs Switch is often mounted and comes with 3 interchangable bases and a 24-inch velcro strap. This guide will cover how to attach the strap to the switch. Once attached, the strap can be wrapped around items such as a headrest or wheelchair arm, allowing the switch to be mounted nearly anywhere. This task should take you less than 5 minutes.
Required Items
- Specs Switch
- 24-inch velcro strap (included)
- Small Philips screwdriver (included)
- Strap base (included)
Instructions
- Thread the velcro strap through the slits on the strap base. The loop (or fuzzy) part of the velcro should be facing the underside of the base.
- Turn the Specs Switch over and remove the 2 screws from the attached large base.
- Aligning the small bump on the base with the small hole on switch, place the strap base onto the switch.
- Replace screws.
- Your switch can now be mounted using the velcro strap.
Tips and Troubleshooting
- The velcro strap may need to be trimmed slightly at the point where the loop section meets the hook section.
- For additional information on AbleNet switches, please visit the Switch Knowledge Base.
- If you have additional questions, please contact the ableCARE Product Success Team for further assistance.