How to Clear All Messages from Your BIGmack – AbleNet

Summary

This article will teach you how to clear the message from your BIGmack speech device. This task should take you less than 3 minutes.

Check the battery in your BIGmack
- Flip the BIGmack over to access the battery compartment.
- Twist the D-shaped clip to open the battery door and check that the device has a 9-volt alkaline battery and that there is no visible corrosion.
- Push the door back into place and twist the D-shaped clip clockwise to secure the battery door.
Power on the BIGmack
- Locate the rotary switch on the back of the BIGmack, opposite the button area.
- Rotate the switch to the right to turn on the BIGmack.
Clear the messages
- Locate the "Record" button on the bottom left side of the back of the BIGmack.
- Press and hold the "Record" button for about 10 seconds or until you hear a beep.
- To confirm that the messages have been cleared, press the top of the switch. The LED record light should blink orange.
- Your BIGmack is now cleared of all previous messages and ready for new ones!

The video below demonstrates this process.

If the process does not work, you may need a new battery. Replace your batteries and try the process again. Follow the battery guidelines below:
- We recommend always using regular, alkaline batteries to avoid any issues with recording or playing messages.
- Do not use batteries labeled “Heavy Duty,” “Industrial Grade,” or “ProCell." These types of batteries handle power differently than regular alkaline batteries, and when used in our devices they behave similar to low or dead batteries.
- Make sure the replacement batteries are new and recently purchased. Batteries that have been used for other devices or those that have been sitting a while may not have the power to operate the switch correctly.
For additional information on BIGmack, please visit the BIGmack Knowledge Base.
If you have additional questions, please contact the ableCARE Product Success Team for further assistance.