How to connect a Big Beamer, Mini Beamer and Jelly Beamer

To connect a Big Beamer, Mini Beamer, or Jelly Beamer Transmitter, you will need to pair it with either an Original Receiver or the PowerLink 4. Information for our receiver options can be found in the following links; 

Original Receiver: https://www.ablenetinc.com/original-receiver/ 

PowerLink4: https://www.ablenetinc.com/connected-home/ 

To connect Big Beamer, Mini Beamer, or Jelly Beamer to the Original Receiver, follow the steps below:

1. Insert new batteries into the Big Beamer or Jelly Beamer Transmitter and receiver of your choice (as needed). For Mini Beamer, make sure that it has been charged for at least 4-6 hours. 
2. Turn ON both the wireless transmitter and receiver
3. Press and hold the Test button on the Original Receiver for about 5 seconds or until the LED turns Green to enter pairing mode
4. Press the switch on top of the transmitter to link it to the receiver. Please note; that you may repeat this step for additional transmitters (up to 8 transmitters can be paired to a single receiver).
5. Press the pairing button on the Original Receiver once to exit the paring mode.

Now your receiver and transmitter are ready to be used!

To connect Big Beamer, Mini Beamer, or Jelly Beamer to PowerLink4, follow the steps below:

1. Connect a PowerLink4 to a power outlet
2. Insert new batteries into the Big Beamer or Jelly Beamer Transmitter. For Mini Beamer, make sure that it has been charged for at least 4-6 hours. 
3. Turn the PowerLink4 ON
4. PoweLink4 has two independent sides that can be activated by a switch. Choose the side that you want to control with the transmitter, then press and hold that side's Status button for about 5 seconds or until the LED next to it turns Green to enter pairing mode.
5. Press the switch on top of the transmitter to link it to the PowerLink4. Please note; that you may repeat this step for additional transmitters (up to 8 transmitters per side can be paired to a PowerLink4).
6. Press the Status button on the PowerLink4 once to exit the pairing mode.

Now your PowerLink4 and Transmitter are ready to be used!