Getting Started With Wireless Receiver

Introduction

The video below offers an introduction and overview of how to use the Product. It will guide you through initial setup, including pairing with an AbleNet Big Beamer or Jelly Beamer Transmitter. You must have one of these wireless switches to use the Wireless Receiver. 

 

Additional Resource Links

• Wireless Receiver Quick Start Guide
• Beamer Quick Start Guide
• Wireless Receiver Instructions for Use
• Beamer Instructions for Use

Tips and Troubleshooting

Connecting to a Wireless Switch

To connect the Original Wireless Receiver to a Jelly Beamer or Big Beamer Transmitter, follow the steps below:

1. Insert new batteries into the Transmitter and Original Receiver. 
2. Turn ON both the Transmitter and Original Receiver
3. Enter pairing mode by pressing and holding the Test button on the Original Receiver for about 5 seconds or until the LED turns green.
4. Press the switch on top of the Transmitter to link it to the receiver. Please note that you may repeat this step for additional transmitters (up to 8 transmitters can be paired to a single receiver).
5. Exit pairing mode by pressing the pairing button on the Original Receiver once.

Batteries

We recommend always using regular, alkaline batteries to avoid any issues with your device. If your device is not working correctly, it may be due to one of two battery issues:

1. Low or Depleted Batteries: The batteries in your device may need to be replaced.
2. Battery Type Issues: If you're using rechargeable batteries or batteries labeled “Heavy Duty,” “Industrial Grade,” or “ProCell,” these types may cause the device to behave as if the batteries are low or dead. These battery types manage power differently from regular alkaline batteries and are not recommended for use with this product.

How to resolve:

• Replace the batteries with new, regular alkaline batteries.
• Make sure the replacement batteries are fresh and recently purchased. Batteries that have been used in other devices or have been sitting unused for some time may not have enough power to operate your device properly.

Additional Support

Please visit the Wireless Receiver Knowledge Base for additional support resources. If you have any additional questions, please contact the ableCARE Product Success team for further assistance.

Don't Forget to Register Your Product

Registering your product provides you access to ableCARE, product updates, and resources for your product. Click here to visit our product registration page to get started.